Drill a 7/16-inch hole in the center of the 3-inch PVC endcap for the Schrader valve and in the 3-inch-diameter pipe for the pressure gauge. Use the ¼-NPT pipe tap to cut ¼-NPT threads in the hole.

Push one end of a roll of drip tubing into the compression fitting side of the hose-to-compression adapter of the first valve (1/2-inch or 5/8-inch tubing is typically used). Drip systems use ...

My system has a one-inch plug hole that connects to the device. To blow out the water, charge up the air compressor and hook ...

It supports valve sizes from 1/2 inch to 1 inch and runs on four AA batteries, offering up to two years of battery life. The low-power Zigbee protocol ensures reliable operation without the hassle ...

STEP 1: Locate the valve that shuts of the water to your irrigation system and turn it to the off position. (Not the whole house, just the irrigation.) This irrigation valve can be located in the ...

PITTSBURGH, July 3, 2025 /PRNewswire/ -- "I wanted to create a cap device for ground-based sprinkler systems to prevent unwanted trash, dirt, and debris from entering the backflow valve interface ...

Connect the flexible drain tube to a 1” three-way valve using a 1” barbed male adapter and a hose clamp. Connect one side of the valve to the sewer standpipe using a 1-inch diameter PVC pipe and ...

PRNewswire/ -- "I wanted to create a cap device for ground-based sprinkler systems to prevent unwanted trash, dirt, and ...