The pinion yoke is removed using a wheel puller as shown. Protect the end of the pinion gear against damage. See All 16 Photos. 05.The pinion seal is removed using a seal remover.

Steve removes the pinion nut and then uses a puller to separate the yoke from the pinion. With the yoke removed, he uses a dead-blow hammer to tap the pinion free from the bearings. See All 71 Photos ...

Read about this Dana 50 Front Differential buildup with a 4.88 Yukon ring and pinion gear set, a master install kit and Timken setup bearings, only on dieselpowermag.com, the official website of ...

The fourth-generation F-body is equipped with GM's 7.5-inch 10-bolt rear axle. It uses a rubber lip-type seal to keep gear lube from slipping past the pinion flange during normal operation.

Fortunately, Ford Racing has the best prices on 3.73:1 ring and pinion gear and bearing kits for the 8.8, so I ordered up a set and called Tech Editor Smith's buddy Tim Moore, who agreed to do the ...

Can I use the ring-and-pinion from a Chevy Dana 60 in a Dodge Dana 60? They are both front axles. The Chevy Dana 60 is from an '89 GM truck and it has 4.10:1 ratio gears in it. The Dodge Dana 60 ...